Other languages  English - Español     

/// Compatibility

Specific features for Group 3 - CAN VISUAL

Digi4Park® incorporates the most advanced LOGIC of operation in order to activate the system by automatically if we detect an obstacle under 10 km/h with the system disconnected in forwards.

Speakers, Sensors, Display and original screens are managed directly by our unit leaving to the driver keeps the attempting into the driving.

Digi4Park® in CAN BUS Mode only requires power and CAN BUS. The interface gets of the CAN the speed, reverse and ignition signals. In this mode the sensor kit automatically activates and deactivates the PDC kit with the speed and rear gear using the Intelligent and Automatic Operation and can be activated or deactivated manually with the switch Parking button.

Digi4Park® in UNIVERSAL ANALOG Mode can be connected to analog signals of the car like Ignition or Speed. If the Speed signal is connected it is also possible to use the Intelligent and Automatic operation mode of the Kit. If you do not have the speed signal or you can not supply it to our Unit Control, Digi4Park will be automatically disabled after removing the reverse for rear and after 10 seconds for front. It can be activated manually by the button. ALL VEHICLES ARE SUPPORTED IN THIS WAY

From factory, Digi4Park® includes 4 sensors for rear installations or front installations, but admits a second group of four sensors to complete front+rear installations with the same Unit Control. Also it is possible to use Digi4Park in the front area in cars with Original Rear Sensors.

Digi4Park® only requires power and CAN BUS, CAN extracting the speed, reverse and ignition signals. In this mode the sensor kit automatically activates and deactivates the speed and can be activated manually with the switch. Additionally the sensor information is shown in the original screens. This group is in permanent updating.

5 items Current Page1 of 1

Copyright 2017 digi4park - Design by digi4park