Other languages  English - Español     

/// I have a Digi4Park® LED Display and the display shows me an initial message type [E1] instead of [–] What can it be?

13 Mar / 2014
Author: admin Tags: There is no tags Comments: 0

Bookmark and Share

If the Digi4Park® LED display show a message during the first two seconds after activation of the type [Ex], indicates that there is an error in a sensor. The “x” is replaced by the number of faulty sensors in total, to indicate the position of the faulty sensors on each side of the vehicle the four red LEDs that are next to the orange digits show the fault sensor. So what red light will means “damaged sensor”. The message disappears after 2 seconds.

Digi4Park® can operate with only one active sensor. Check the installation manual for more information on this topic.

Posted in: 2. End user tech support and troubleshooting




/// There are no comments yet, but you can be the first

Comments are closed.


Copyright 2017 digi4park - Design by digi4park