Other languages  English - Español     

/// Structured Wires +

In Digi4Park® you will find 3 different types of cables, SENSORS WIRE, EXTENSION WIRE and POWER WIRE. The first two ones, allow you to connect every sensors area of ​​vehicle to the control unit. The POWER WIRE connects the unit to the vehicle. For the latter we have specific Plug & Play wires, apart from the universal version that comes from factory default
SENSORS WIRE, EXTENSION WIRE & POWER WIRE, nothing more


ONLY 2 WIRES FOR EVERYTHING

The same Digi4Park® UNIT CONTROL can be used for Rear, Front or for Rear+Front installation, that means 4 or 4+4 sensors. In order to install the Interface Box to the sensors areas there are only needed TOW diferent wires. Also it is necessary to use the POWER/CAN wire that it is included in the packs

In order to connect sensors to UNIT CONTROL, we use 2 types of wires:

BROWN REAR or FRONT Wiring

ORANGE EXTENSION Wiring

  • SENSOR WIRING: BROWN This wire is used in order to Interconnect all sensors of one side of the car (FRONT or REAR) to Digi4Park® digital BUS, giving at the same time, power to each sensor.This wire ends in the BUMPER in IP64 connector in order to be connected to the EXTENSION WIRING, Extension wire that it is the only wire that comes into the car.
  • EXTENSION WIRING: ORANGE This wire is used in order to Interconnect the REAR or FRONT sensor wiring with the Digi4Park® Interface box. This wire ends in a 6 pin IP64 waterproof connector outside of the car. The length of this wire is more 550 cm.

THE PLUG & PLAY WIRES FOR POWER & CAN

In some vehicles or in some special way to comercialize Digi4Park® (for car importers or manufacturers), could be important to leave the original installation and wiring of the car from factory without any cut and change. For that situations we have a complete set of Plug & Play wires that we can supply by option. Please check in the Car Compatibility Data Base if there is P&P wire for your car or even BY THIS LINK.

estructures_wires
wire_conector

IP65 MAXIMUN PROTECTION

All connections that we have used for external areas in Digi4Park, like sensor connection or interconnections between wires, are metalic ones and waterproof with IP65 protection. The connector has special tabs that can prevent erroneously and sealing rubbers connect to ensure tightness.

When we decided to design the Digi4Park® wiring , we used as the example of a wiring system parking sensor factory installed and we adapted it to facilitate the work of the installer while allowing easy maintenance in the future, if for example removing the bumpers require
Everything has been designed to make work easier for the installer

 

Copyright 2017 digi4park - Design by digi4park